Weslo 900 user manual Assembly, Wheels 63 are in the indicated position

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex keys and your own phillips screwdriver		, wire cutters
and needlenose pliers	.

For help identifying the assembly hardware, see the PART IDENTIFICATION CHART in the centre of this manual. Note: The assembly hardware and other small parts are packaged in separate part bags. Do not open the part bags until instructed to do so.

1. Make sure that the power cord is unplugged.	1			60
Place the Base (79) in the position shown, with the indi-		Small Hole		73
cated small holes on top. Next, place the Wheels (63)
into the ends of the Base.	60
Open part bag A. Attach the Wheels (63) to the Base	61	73	79
(79) with 2” Bolts (61) and Wheel Nuts (64). Make sure
that the Wheel Nuts are on the sides shown; do not
overtighten the Bolts; the Wheels should turn freely.		64
Attach the four Base Pads (73) to the Base (79) with four	63		60
1” Tek Screws (60) (three are shown).
		64	73
		63
				61
2. Raise the Base (79) to a vertical position, and hold it	2
near the treadmill Frame (96) as shown. Make sure that
the Wheels (63) are in the indicated position.		58
Identify the Right Upright (104), which has a large round	57
	47
hole in the indicated location. Feed the Wire Harness		79
(65) into the hole and out of the top of the Right Upright.
Make sure that there are two U-nuts (74) in the lower
end of the Right Upright (see drawing 2a). Hold the Right
Upright against the Base (79) as shown. Make sure that				58
the Right Upright is oriented so the pivot hole is in the
position shown. Hand tighten two 3” Bolts (58) with two		104
5/16” Star Washers (57) into the Base and the Right
Upright.	Pivot			57
	Holes
Attach the Left Upright (47) to the Base (79) in the same
				Round
way. Note: There is not a wire harness on the left side.
				Hole
	2a
With the help of a second person, raise the Uprights (47,				65
	104	96
104) to a vertical position.
	74			63

6