3.Carefully rotate the Console Base (45) to the posi- tion shown. Tighten four Handrail Screws (85) into the Console Base and the Upright (37) as shown.
Refer to the inset drawing. Tighten the four Handrail Screws (85) that are already in the Upright (37).
Tighten all eight Handrail Screws (85) as tightly as possible. Carefully lift up and push down on the handrails to make sure that the Console Base
(45)does not move. Regularly inspect and tight- en all eight Handrail Screws.
4.Attach the Frame Guide (66) and the Frame Guide Spacer (84) to the left side of the Frame (21) with two Frame Guide Screws (77) as shown. Note: Be careful not to overtighten the Screws. Make sure that the thick end of the Frame Guide is at the bottom.
5.Remove the backing from the Adhesive Clip (2). Press the Adhesive Clip onto the base of the Upright
(37)in the indicated location. Press the Allen Wrench (35) into the Adhesive Clip.
6.The Console (49) requires two "AA" batteries (not included); alkaline batteries are recommended.
Open the Battery Cover (48) as shown. Press two batteries into the battery compartment, with the neg- ative (Ð) ends of the batteries touching the springs. Close the Battery Cover.
7.Make sure that all parts are properly tightened before you use the treadmill. The use of the remain- ing parts will be described in other sections of this manual. To protect the floor or carpet from dam- age, place a mat under the treadmill.
6
3 |
| 45 |
|
|
|
|
|
| |
85 | 85 | 85 |
| 85 |
|
| 37 |
|
|
| Handrails | 45 |
| |
85 | 85 |
| 85 | 85 |
|
| 37 |
|
|
4 |
|
|
|
|
| 84 |
|
|
|
77 | 66 |
|
|
|
|
|
|
| |
|
| 21 |
|
|
| Thick end |
|
|
|
5 |
|
|
|
|
|
| 37 |
| |
|
| 2 |
|
|
|
|
|
| 35 |
6 |
|
|
|
|
| 49 | 48 |
|
|
|
|
|
| |
Batteries |
|
|
|