7.In no less than a minute, press lever 5 (fig. 1) in the arrow indicated direction in order to engage the stabilizing mode and hold it in this position while observing.
ATTENTION! It is not allowed to engage the stabilizing mode of the device when the power supply control indicator is not glowing, or in less than a minute after device has been turned ON.
When finishing the observation
release lever 5 (fig. 1). The lever should return to the initial position. Now the stabilizing mode has been switched off. Switch OFF the power supply unit.
5.3.Preparing the Device for Operation from On-board Source
1.Replace the cartridge with batteries 1 (fig. 2) with a voltage transformer available in the complete set of the device.
2.Connect the cable, supplied in the complete set, to the power supply unit connector 2 (fig. 2).
3.Connect the device to the
4.Then prepare the device for operation as outlined in the paragraph 5.2.
10
3. TECHNICAL CHARACTERISTICS
Magnification | 16x | |
Angular field of view | 3.4° | |
Exit pupil diameter, mm | 2.5 | |
|
| |
Minimum focus, m | 30 | |
Interpupillary adjustment, mm: | 58 – 72 | |
Dioptric adjustment, not less, dptr | ±5 | |
Transmission factor, not less | 0.55 | |
Parallelism of eyepiece axes of sight: |
| |
- Divergence on vertical plane, not exceeding: | 20’ | |
- Convergence on horizontal plane, not exceeding: | 20’ | |
- Divergence on horizontal plane, not exceeding: | 60’ | |
Power source (batteries): | 6 (AA) | |
From an | 12 | |
Angular velocity of panning in any | 0 - 6 | |
direction, degree/sec: | ||
| ||
Stabilization freedom, degrees | ±5 | |
Overall dimensions, mm: | 215×190×96 | |
Weight (w/o batteries), kg, | 1.98 | |
Relative humidity (at +25°C) %: | up to 98 | |
Temperature range, °C | ||
Temperature range during transportation, oC | ||
7 |
|