Comprehensive Guide to the ATN PS14 Binoculars: Installation and Features

450 MW INFRA-RED ILLUMINATOR

The 450 mW IR Illuminator works on a sepa- rate battery from the main unit. To install the battery unscrew cap and insert battery in the same direction as depicted by the diagram on the IR. To install the 450mW IR Illumina- tor to the scope screw the adapter into the thread on the scope. Install IR to the rail of adapter and screw fixator.

The IR illuminator control buttons are located on its side. To switch the Digital IR illuminator on/off press “+” and “-” buttons simultaneously. When the IR illuminator is switched on you can see the green LED lit. By pushing the buttons “+” and “-” you may adjust the IR brightness.

Battery	IR Brightness Adjustment
Housing	IR Elevation
	IR Elevation
Adapter
Fixation
Screw	IR Windage IR Focusing

The IR beam is focusable to change the field

of coverage. To change the beam width slightly turn the IR lens.

You could change the IR control panel fitting your needs. The screw-tool included into the set should be used for weakening the fixing screw located on the IR. Rotate the IR placing it in the most convenient position. Tighten the screw with the screw-tool to fix the new position.

FLIP-UP HEADSET

PART I

1)The first step that you want to take in mounting PS-14 on your head is to fit the headgear to your size. Adjust the headgear fist before attaching the PS-14 to it.

2)Loosen all the straps and place the head- gear on your head.

3)You will want to tighten the straps.

PART II

Now you are ready to mount the PS-14 on to your headgear.

1)Remove the already adjusted headgear from your head.

2)Screw the thumb screw [1] to the mounting thread in the body of PS-14.

3)Get the headgear on with PS-14 onto the head.

4)Loosen the screw [2] and move the unit along the rail for eye relief adjusting .

The PS-14 headset has a flip-up mechanism. Push a button [3] on the side of mount and lift the unit up till a fixation in the top position.

You can use PS-14 for left eye. Loosen the screw [4] and rotate unit to new position.