Bushnell Nov-00 specification

•High/Low Quality (LQ) : When “LQ” is displayed, pressing “OK” will set the camera to low resolution mode (320x240 pixels)-the “LQ” icon will stop blinking. LQ mode will allow you to fit more photos in the memory before you stop to download them, with the tradeoff of less quality per photo. To reset the camera to high resolution, return to the LQ mode, and press SNAP again (“LQ” will no longer be displayed). When the LQ icon is off, the camera is in high resolution mode (640x480 pixels) for best quality.

•AVI Mode: ( ) : This mode sets the camera to take short movie clips (.avi files) rather than still photos. After this mode has been activated (press SNAP when the movie icon blinks), holding down the SNAP button will film an avi movie until you release it (or the memory is full). When the SNAP button is released, the camera reverts back to normal still photo operation (assuming unused memory remains). Repeat the steps to set AVI mode again if you wish to shoot more movie clips.

•Power Frequency Setting: (60/50 Hz): This sets the correct electrical frequency to avoid any “flickering” in the camera’s output. The normal default is “60” Hz (cycle), as used in the United States. If you are using the camera in a country with 50 Hz power frequency, press SNAP when the “50” icon blinks to select it.

•Delete Last ( ) : Pressing SNAP when the “Delete Last” icon is blinking will delete (erase) the last photo you took from the camera’s memory.

•Delete All ( ) : When this mode is selected, the word “ALL” appears next to the trash can icon, and the number of total photos in memory will blink in the display. Press and hold the SNAP button to