Maintenance and TROUBLE-SHOOTING

Inspect and tighten all parts of the CARDIO FIT PLUS regularly. Keep the monitor out of direct sunlight or the display may be damaged. The CARDIO FIT PLUS can be cleaned with a soft, damp cloth. Keep liquid away from the monitor. When storing the CARDIO FIT PLUS. remove the batteries from the monitor,

HOW TO REPLACE THE BATrERIES

If the display of the Monitor (1) becomes dim, the two L1154 watch batteries should be replaced. Lift the Monitor off the Frame (6): Disconnect the Sensor Wire (15) from the Monitor. Remove the four screws from the back cover of the Monitor and remove the back cover (see the inset drawing).

Push the two old batteries out of the battery clips, noting which way each battery is turned. Insert two new batteries.

Reattach the back cover of the Monitor (1). Connect the Sensor Wire (15) to the Monitor. Insert all excess wire into the Frame (6). Press the Monitor onto the Frame.

HOW TO ADJUSTTHE MAGNET AND REED SWITCH

"If the monitor displays incorl'eCtfeedback, the Magnet (27) and the Reed Switch (15) shouk:lbe checked. Pivot the Pedal

Frame (32) until the Magnet is aligned with the Reed Switch. Slightly loosen the #8 x 3/4" Screw (18) in the Reed Switch. Slide the Reed Switch slightly closer to the Magnet. Tighten the #8 x 3/4" Screw. Exercise on the CARDIO FIT PLUS for a moment. Repeat uhtil the monitordisplays correct feedback.

Make sure that the Magnet does not hit the Reed Switch.

HOW TO LUBRICATE THE CARDIO FIT PLUS

Every three months, a small amount of light multi-purposeoil should be applied to the CARDIO FIT PLUS. Apply a few drops of oil between the dome caps and the frame in the locations shown at the right. Make sure to apply oil to both sides of the CARDIO FIT PLUS.

Screws

Apply Oil