Cannon DIGI-TROLL 5 TS Fishing With Your Downrigger, Manual Descent, Positive Ion Control System

Page 24

Fishing Theory

Fishing With Your Downrigger

After programming your Digi-Troll, release some line from your rod and reel so that the lure is anywhere from 5 to 100 feet behind the boat. This is called drop back.

Attach the fishing line firmly into the line release. Press and hold the down key to lower the weight to the desired depth as indicated on the display or select a pre- programmed weight depth. Place the fishing rod in the rod holder and reel up the slack so that your rod has a slight bend in it. When a fish strikes the lure, the line will separate from the release. Then you will be free to fight the fish and bring it in on your rod and reel.

Manual Descent

By turning the clutch knob gently clockwise (toward the boom), you can let your trolling weight descend as fast or as slowly as you wish. Turning the knob counter- clockwise (away from the boom) stops the weight. This gives you control to let it plunge rapidly or sink slowly to a predetermined trolling depth. With multiple downrig- gers, you could start all your weights creeping down, one at a time, and then stop them each in turn.

Note: In order to track line out, the Digi-Troll must be turned on.

WARNING—DO NOT TOUCH THE CABLE REEL WHILE THE DOWNRIGGER IS IN USE!

The Positive Ion Control System

Your boat has an electrical charge around the hull in water. If a boat is properly grounded and has a proper zinc anode, that charge should be slightly positive when measured from ground to the downrigger cable. Positive Ion Control (PIC) is the use of electricity to control that charge and its fluctuation so that it is always maintained at a specified set voltage.

The practice of setting up and maintaining a slight positive charge on fishing gear has been used by com- mercial fishermen for many years. This practice has en- abled some fisherman to increase yield when used along with other good fishing and boating practices.

Cannon's electric downriggers offer fishermen a big advantage in being able to stabilize and control the posi- tive charge around their boat. Because of the composite construction of the frame, Cannon downriggers are insu- lated from your boat's hull charge.

When the stainless steel downrigger cable is low- ered into the water, the natural ionization between the cable and the boat creates a positive charge of 0.7 to

0.9volts in saltwater and 0.3 to 0.6 volts in fresh water. This natural voltage is dependent upon salinity and min- eral content of the water. Your actual voltage may vary.

The Short Stop System

The Short Stop system is composed of three critical components: the electronic unit, the reel conductive path, and the trolling weight insulator.

While the downrigger cable is in the water, there is a minute electrical current that flows between the cable and the grounded metal boat components in the water. When the cable clears the water, this current flow will stop. The Short Stop system senses this interruption and turns off the motor. The trolling weight insulator is used to break the cable contact to the water while the weight is still in the water. The reel conductive path al- lows the circuit path to be made through the structure of the downrigger.

NOTE: It may be necessary to use two trolling weight insulators.

NOTICE: Short stop and Positive Ion Control features do not function when spooled with monofilament or super lines.

Stopping the weight at water level eliminates the cable strain caused by bouncing weights or weights hit- ting the boom end. Stopping at water level will also keep the weight from hitting the boat hull.

24

www.cannondownriggers.com

Cable Terminator

Weight Insulator

Image 24
Contents DIGI-TROLL 5 DIGI-TROLL 5 TS Table of Contents Safety and Cautions Warranty and RegistrationIntroduction Overview Cannon Limited Warranty Reel BoomSwivel Head CableInstalling the Base on Your Boat Decks up to 7/16 thick Downrigger Mounting on BoatsDecks thicker than 7/16 Decks thinner than 1/4 Low-Profile Swivel BaseInstalling the Boom and Ball Hook Telescopic Boom only Boom END Pulley Telescopic BoomRemovable Spool Cover Removing or replacing the spoolReplacing the Clutch PAD Attaching the ROD HoldersTerminating the Downrigger Cable Using Your DIGI-TROLL with the Intellitroll Accessory Using the Included Power Loss Manual Crank Handle Electrical Specifications & Wiring Instructions Connecting to the BatteryYour Boats Electrical Condition Fuse / Breaker Specifications Powering Multiple DownriggersTypical Operating Time Red + Black Connect Multiple Batteries in ParallelOperating the Digi-Troll Digi-Troll 5 DisplayLCD Icon Layout Menu DownWater Zero Auto UPProgramming the Digi-Troll Menu SystemDownrigger when connected to Cannonlink Digi-Troll Factory Settings Un/Coated MenuOptional Intellitroll Accessory Networking your Digi-TrollsCable Terminator Weight Insulator Fishing With Your DownriggerManual Descent Positive Ion Control SystemUsing Positive Ion Control There are no user serviceable parts internal toDigi-Troll. Your warranty will be void if opened by Anyone other than an authorized or factory serviceMPH Ten Good Trolling Tips Consider special knots and swivels. a good ballConsider releases for flatline trolling. a good tip Troubleshooting ProblemSolution This page Intentionally Left Blank Digi-Troll List Parts Digi-Troll 5 TS 32 9100070 CON Leader Sleeve Digi-Troll 5 Series Wiring Diagram Page Environmental Compliance Statement

DIGI-TROLL 5, DIGI-TROLL 5 TS specifications

The Cannon DIGI-TROLL 5 TS and DIGI-TROLL 5 are sophisticated trolling motor controllers that represent a leap forward in fishing technology. Designed for the angler who demands precision, efficiency, and ease of use, these devices offer a suite of features that enhance the fishing experience.

A standout feature of both models is the integrated digital depth counter, which provides real-time readings of the depth at which the bait is deployed. This valuable information allows anglers to optimize their lure presentation and accurately target specific species. The ability to monitor depth digitally eliminates the guesswork and ensures that the bait is presented where the fish are most likely to be.

The DIGI-TROLL series also boasts advanced line counter technology, enabling users to track how much line has been let out. This feature is particularly beneficial when trolling multiple lines, as it helps maintain consistent bait depth and spacing. The precise line counter enhances productivity by reducing tangles and ensuring that each line is effectively set at the desired depth.

Another significant characteristic is the dual-speed control that both models offer. This allows users to customize the speed of their downrigger, giving anglers the versatility to adapt to changing conditions or particular fish behavior. The DIGI-TROLL 5 TS takes this a step further with a feature for auto-stop, which helps prevent overrun and provides added convenience when adjusting settings.

Furthermore, both the DIGI-TROLL 5 TS and DIGI-TROLL 5 come with intuitive, user-friendly interfaces. Backlit LCD displays make it easy to read information even in low-light conditions, which is vital during early morning or late evening fishing trips. The buttons are strategically placed for quick adjustments, ensuring that anglers can focus on catching fish rather than fiddling with complex settings.

Durability is another hallmark of the DIGI-TROLL series. Built to withstand the rigors of the marine environment, these devices feature corrosion-resistant materials that ensure longevity even under harsh conditions. The Cannon DIGI-TROLL 5 TS and DIGI-TROLL 5 are not just tools, but reliable companions that enhance every fishing outing.

Whether you are a seasoned pro or a weekend warrior, the Cannon DIGI-TROLL 5 TS and DIGI-TROLL 5 offer essential features and robust technology to elevate your fishing game. With these innovative trolling motor controllers, the path to a successful day on the water is clearer and more efficient than ever before.