Cannon Mag 5 Hs, MAG 10HS, Mag 10ts owner manual Blowback Charts, Trouble Shooting

Page 13

Blowback Charts

 

8-Lb. Weight at 2, 4, and 6 MPH

Actual

2 MPH

4 MPH

Depth

6 MPH

of Weight (ft.)

 

 

Amount of Cable in Water (ft.)

 

10-Lb. Weight at 2, 4, and 6 MPH

 

2 MPH

ActualDepth

4 MPH

6 MPH

of Weight (ft.)

 

 

Amount of Cable in Water (ft.)

 

12-Lb. Weight at 2, 4, and 6 MPH

ActualDepth

2 MPH

6 MPH

 

4 MPH

of Weight (ft.)

 

Trouble Shooting

PROBLEM: Up or down will not work.

SOLUTION:

Check the battery cable polarity then check the battery voltage.

A properly connected and charged battery is important for safety and for proper operation of the downrigger.

PROBLEM:

The Mag 10HS \ Mag 10TS \ Mag 5HS fails to continue running after toggle switch is pushed up and held momentarily, while cable is still in water, or is having problems with the PIC voltage.

SOLUTION:

Make sure your boat is properly bonded. A boat that is properly bonded has an electrical path from the negative battery terminal to all metal parts on the boat that contact water. Additionally, in saltwater the boat must be properly zinced to show a natural electrolysis voltage of 0.7 to 0.9 volts. The voltage supply to your downrigger must also be bonded to the boat.

PROBLEM:

Clutch slips

SOLUTION:

The set screw in the reel may have come loose off the shaft. Follow the instructions below:

1)Unwind the cable from the reel.

2)Remove the set screw.

3)Align the set screw hole in the reel with the hole in the reel shaft by inserting a 3/16" or smaller rod and rotating the reel until you feel it drop into the shaft hole.

4)Replace the set screw and tighten until you feel resistance.

5)By gently rocking the reel back and forth while tightening the set screw, you can feel it engage in the shaft hole. The half dog point on the set screw must enter the hole in the shaft; not just be tightened against the reel shaft.

6)The set screw should be about 1/16" above the top of the hole when it is properly seated (not so for TS models). The contact between the stainless steel cable and the set screw is important for proper operation of the Positive Ion Control system.

Blowback & TROUBLE SHOOTING

Amount of Cable in Water (ft.)

13

Image 13
Contents MAG 10HS MAG 10TS MAG 5HS Boom Parts DescriptionDownrigger Mounting on Boats Mounting AccessoriesPedestal Mounting Side Rail MountingDecks up to 7/16 thick Installing the Base on Your BoatDecks thicker than 7/16 Decks thinner than 1/4Mounting the Downrigger on the Base Setting Up Your DownriggerAttaching the Boom Cannon Uni-Release Terminating the Downrigger CableAttaching the Rod Holder Electrical Specifications & Wiring Instructions Wiring Your DownriggerConnecting to the Battery Your Boats Electrical ConditionPowered Descent One speed fits all Lowering the WeightRaising the Weight Operating Your DownriggerShort Stop System Adjusting the Depth MeterMaintaining Your Downrigger Positive Ion Control System Using Positive Ion ControlBlowback Trouble Shooting Blowback ChartsTen Good Trolling Tips Cannon Limited Warranty Environmental Compliance Statement