DIAGRAM OF THE CONSOLE
Monitor Displays | LED Track |
Incline Control | Clip | Key | Speed Control | Pulse Sensor |
CAUTION: Before operating the console, read the following precautions.
¥Do not stand on the walking belt when turning on the power.
¥Always wear the clip while using the treadmill. When the key is removed from the console, the walking belt will stop.
¥An emergency
¥Adjust the speed in small increments.
¥The settings marked above the speed control
¥To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle.
STEP BY STEP CONSOLE OPERATION
If there is a thin sheet of clear plastic on the face of the console, remove it. Next, make sure that the power cord is properly plugged in (see HOW TO PLUG IN THE POWER CORD on page 7).
Stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing.
Follow the steps below to operate the console.
1Insert the key fully into the power switch.
After a moment, the four displays and one indicator in the LED track will light.
2Reset the speed control.
Slide the speed control to the the RESET
position. Note:
Each time the
walking belt is stopped, the
speed control must be moved to the RESET po- sition before the walking belt can be restarted.
3Start the walking belt.
Slowly slide the speed control to the right until the walking belt begins to move at slow speed. Step onto the walking belt. Change the speed of the walking belt as desired by sliding the speed control.
To stop the walking belt, step onto the foot rails and slide the speed control to the RESET posi- tion. After a few seconds, the displays will pause.
7