TREADMILL ADJUSTMENTS
WALKING RESISTANCE
The walking resistance or effort needed to push the treadmill belt can be adjusted by changing the incline angle. This treadmill has two adjustment positions.
Highest Resistance | Lowest Resistance |
The BUMPER STANDS(20) are attached to | Remove (unscrew) the BUMPER STANDS(20) |
the bottom of the treadmill. | from the bottom of the treadmill and store them |
| in the end of the treadmill. |
NOTE:
1.Since this is a new machine, you may need some time to get used to walking on the treadmill and to break it in.
2.If the walking resistance is still too high, check the BELT TENSION.
3.The belt resistance can be reduced by adding silicone lubricant between the belt and the board. Wipe the board under the belt with a cloth and spray or spread silicone lubricant on the board under the belt.
MAINTENANCE
The safety and integrity designed into the INMOTION
T3000 Treadmill can only be maintained when the INMOTION T3000 Treadmill is regularly examined for damage and wear. Special attention should be given to the following:
1.Clean the exposed surfaces of the walking belt and the board with an absorbent cloth.
2.It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
3.Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts. Tighten loose nuts and bolts.
4.Verify that the Warning Label is in place and easy to read. Call Stamina Products immediately
5. | Worn or damaged components shall be replaced immediately or the INMOTION T3000 Treadmill |
| removed from service until repair is made. |
6. | Only Stamina Products supplied components shall be used to maintain/repair the INMOTION T3000 |
| Treadmill. |
7. | Keep your INMOTION T3000 Treadmill clean by wiping with an absorbent cloth after use. |
8.If the WALKING BELT(15) does not move easily, lubricate the BOARD(16) under the WALKING BELT(15) with Silicone Lubricant.
12