Stamina Products 45-1003 owner manual Foam GRIPS22

Page 8

ASSEMBLY INSTRUCTIONS

Slide down the

upper parts of the

FOAM GRIPS(22)

for assembly.

STEP 2

Place the BASE FRAME(1) between the LEFT and RIGHT UPRIGHTS(2, 3) and secure with HEX BOLTS(M12x1.75x75mm)(35) and WASHERS(M12)(45). DO NOT TIGHTEN COMPLETELY.

STEP 3

Slide down the upper parts of the FOAM GRIPS(22), so you can see the screw holes at the back side of the tops of the LEFT and RIGHT UPRIGHTS(2, 3). Connect the UPPER EXTENSION WIRE(26) to the LOWER EXTENSION WIRE(27). Insert the U-SHAPED HANDRAIL(5) into the LEFT and RIGHT UPRIGHTS(2, 3) and secure with BUTTON HEAD BOLTS(M6x1x15mm)(36) and ARC WASHERS(M6)(41). Slide up the FOAM GRIPS(22) to cover the screw heads.

STEP 4

Go back and tighten HEX BOLTS(M12x1.75x75mm)(35) in STEP 2. Connect the LOWER EXTENSION WIRE(27) located on the LEFT UPRIGHT(2) to the SENSOR WIRE(28). Insert the PULL PIN(6) through the RIGHT UPRIGHT(3) and BASE FRAME(1) to lock the BASE FRAME(1) in position.

8

Image 8
Contents This Product is Produced Exclusively by Stamina ProductsSafety Instructions Table of ContentsCall US First 800Before YOU Begin Inmotion T3000 TreadmillEquipment Warning & Notice Labels Hardware Identification Chart Part No. and DescriptionAssembly Instructions StepFoam GRIPS22 Extension WIRE26 to the METER24 Functions Using the Electronic MeterHOW to Install and Replace Battery Treadmill Adjustments Belt AlignmentBelt Tension Belt Drifting LeftTreadmill Adjustments Walking Resistance MaintenanceStorage Unfold the Inmotion T3000 TreadmillProduct Parts Drawing BackDIAGRAM# Part Name QTYLimited Warranty WarrantyPage FAX/MAIL Ordering Form Stamina Products, Inc Box Springfield, MO