Stamina Products Inmotions owner manual Treadmill Adjustments Walking Resistance, Maintenance

Page 10

TREADMILL ADJUSTMENTS

WALKING RESISTANCE

The walking resistance or effort needed to push the treadmill belt can be adjusted by changing the incline angle. This treadmill has two adjustment positions.

Highest Resistance

Lowest Resistance

The BUMPER STANDS(22) are attached to

Remove (unscrew) the BUMPER STANDS(22)

the bottom of the treadmill.

from the bottom of the treadmill and store them

 

in the end of the treadmill.

NOTE:

1.Since this is a new machine, you may need some time to get used to walking on the treadmill and to break it in.

2.If the walking resistance is still too high, check the BELT TENSION.

3.The belt resistance can be reduced by adding silicone lubricant between the belt and the board. Wipe the board under the belt with a cloth and spray or spread silicone lubricant on the board under the belt.

MAINTENANCE

The safety and integrity designed into the InMotionTM II Treadmill can only be maintained when the InMotionTM II Treadmill is regularly examined for damage and wear. Special attention should be given to the following:

1.Clean the exposed surfaces of the walking belt and the board with an absorbent cloth.

2.It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

3.Verify that the Spring Pin is present and functioning properly. Verify that the Ball Knob is securely attached to the Spring pin. Repair or replace parts as necessary.

4.Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts. Tighten loose nuts and bolts.

5.Verify that the Warning Label is in place and easy to read. Call Stamina Products immediately (1-800-375-7520) for a replacement Warning Label if the Warning Label is missing or damaged.

6.Worn or damaged components shall be replaced immediately or the InMotionTM II Treadmill removed from service until repair is made.

7.Only Stamina Products supplied components shall be used to maintain/repair the InMotionTM II

Treadmill.

8.Keep your InMotionTM II Treadmill clean by wiping with an absorbent cloth after use.

9.If the WALKING BELT(17) does not move easily, lubricate the BOARD(18) under the WALKING BELT(17) with Silicone Lubricant.

10

Image 10
Contents 45-1002 Weight on this product should not exceed 250 lbsCustomer Service Number 800 Stamina ProductsSafety Instructions Table of ContentsCall US First Monday Friday, 800 A.M. 500 P.M., Central TimeBefore YOU Begin InMotionTM II TreadmillHardware Identification Chat Assembly Instructions StepAttach the Bumper STANDS22 to the bottom of the Base FRAME1 HOW to Install and Replace Battery Using the Electronic MeterFunctions Belt Tension Treadmill AdjustmentsBelt Alignment Belt Drifting LeftMaintenance Treadmill Adjustments Walking ResistanceTreadmill Storage Remove the Pull PIN9 to unlock the Base Frame ASSEMBLY1Remove the Pull PIN11 from the Right Upright FRAME3 Product Parts Drawing BackDIAGRAM# Part Name QTYWarranty Limited WarrantyModel FAX/MAIL Ordering Form Telephone FAX Online Mail