Stamina Products Inmotions owner manual Assembly Instructions, Step

Page 6

ASSEMBLY INSTRUCTIONS

Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all packing materials from your area and place them back into the box. Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning. If you are missing a part please call our toll-free number for assistance 1 (800) 375-7520or e-mail us at:

parts@staminaproducts.com

Sensor Wire

STEP 1

NOTE: The LEFT UPRIGHT(2) is the one with the Sensor Wire.

Attach the LEFT and RIGHT UPRIGHTS(2, 3) to the UPRIGHT SUPPORT(4) with HEX BOLTS (M10 x 20mm)(38) and WASHERS(M10)(47).

STEP 2

Slide the SPRING(7) onto the SPRING PIN(6). Insert the threaded end of the SPRING PIN(6) through the collar on the RIGHT UPRIGHT(3) and screw the BALL KNOB(8) onto the thread end of the SPRING PIN(6). Tighten the BALL KNOB(8) as tight as you can by hand.

6

Image 6
Contents 45-1002 Weight on this product should not exceed 250 lbsCustomer Service Number 800 Stamina ProductsSafety Instructions Table of ContentsCall US First Monday Friday, 800 A.M. 500 P.M., Central TimeBefore YOU Begin InMotionTM II TreadmillHardware Identification Chat Assembly Instructions StepAttach the Bumper STANDS22 to the bottom of the Base FRAME1 Using the Electronic Meter HOW to Install and Replace BatteryFunctions Belt Tension Treadmill AdjustmentsBelt Alignment Belt Drifting LeftTreadmill Adjustments Walking Resistance MaintenanceTreadmill Remove the Pull PIN9 to unlock the Base Frame ASSEMBLY1 StorageRemove the Pull PIN11 from the Right Upright FRAME3 Product Parts Drawing BackDIAGRAM# Part Name QTYLimited Warranty WarrantyModel FAX/MAIL Ordering Form Telephone FAX Online Mail