Stamina Products 55-1539A owner manual Assembly Instructions

Page 8

ASSEMBLY INSTRUCTIONS

STEP 4

Attach the FOOTREST(13) onto the HEIGHT ADJUSTMENT BEAM(12) with the ADJUSTMENT KNOB(24). NOTE: The four adjustment holes in the FOOTREST(13) allow the FOOTREST(13) to be attached in four different positions. Start with one of the center positions and adjust if necessary. Use the outer position if users are taller than average. Use the inner position if users are shorter than average.

STEP 5

Insert the HEEL HOLDER TUBE(17) through the hole on the HEIGHT ADJUSTMENT BEAM(12) and secure with HEX BOLT(M6x1x47mm)(44), WASHERS(M6)(50), and NYLOCK NUT(M6x1)(48). Place a HEEL HOLDER BRACKET(18) onto a HEEL HOLDER(19), then slide them onto HEEL HOLDER TUBE(17) together. Repeat on other side.

STEP 6

Insert the OUTER PAD TUBE(15) through the hole on the LEVER(56). Insert the INNER PAD TUBE(14) into the OUTER PAD TUBE(15). Align the holes on the INNER PAD TUBE(14), OUTER PAD TUBE(15), and LEVER(56), then bolt them together with HEX BOLT(M6x1x42mm)(43), LOCK WASHER(M6)(67), and WASHER(M6)(50). Slide the FOAM PADS(16) onto the INNER and OUTER PAD TUBES(14, 15).

WARNING: The PAD TUBES(14, 15) must be assembled with the ends pointed downward as shown. The ends must be pointed downward to properly secure the users feet in place during inversion. Improper assembly will allow the user's feet to come loose and the user will fall from the inversion table.

8

Image 8
Contents 2040 N. Alliance, Springfield, MO Table of Contents Safety InstructionsCall US First Before YOU Begin Inversion SystemNylon Bed Wrench Combination WrenchEquipment Warning & Notice Labels Hardware Identification Chart 100 110 120 130 140 150Assembly Instructions StepAssembly Instructions Buckle Right Operational Instructions General Precautions Height AdjustmentHandrails Tighten the Securing KNOB23PADS16 Operational Instructions Heel Holder USE and AdjustmentUsing the Inversion Table Recovery from Locked Position Maintenance InstructionsOperational Instructions Suggestions for USE Locking the BEDProduct Parts Drawing DIAGRAM# Part Name QTYDIAGRAM# Part Name QTY Limited Warranty Page Stamina Products, Inc Box Springfield, MO Rear Unit AssemblyFAX/MAIL Ordering Form