ASSEMBLY INSTRUCTIONS
The Protrusion |
faces to the front. |
STEP 3
NOTE: The RIGHT PEDAL(36) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(36) has right hand threads and is tightened by turning clockwise. The LEFT PEDAL(35) has L stamped on the end of the pedal shaft. The LEFT PEDAL(35) has left hand threads and is tightened by turning counter clockwise.
Thread the RIGHT PEDAL(36) to the right side of the CRANK(7) as shown. Tighten the pedal securely. Do the same to attach the LEFT PEDAL(35) to the left side of the CRANK(7).
STEP 4
Refer to the Illustration. Make the protrusion in the POST BUSHING(42) face to the front. Insert the POST BUSHING(42) into the MAIN FRAME(1). Slide the POST SLEEVE(33) onto the MAIN FRAME(1).
STEP 5
Attach the SEAT(44) to the SEAT POST(6) with NYLOCK NUTS(M8x1.25)(60) and WASHERS(M8)(67). Slide the BELLOWS(41) over the SEAT POST(6). Insert the SEAT POST(6) into the MAIN FRAME(1) and secure with the ADJUSTMENT KNOB(43).
NOTE: The ADJUSTMENT KNOB(43) should be screwed in tight to make the SEAT POST(6) fit securely in the MAIN FRAME(1).
8