Stamina Products 55-5516 owner manual Assembly Instructions

Page 8

ASSEMBLY INSTRUCTIONS

STEP 4

Remove the paper covering from the foam tape inside the FRONT COVER(7) and REAR COVER(8). Place the FRONT COVER(7) over the end of the FRONT FRAME(1). Place the REAR COVER(8) over the end of the REAR FRAME(2). Press the covers securely in place.

NOTE: The securing SCREWS(M6x1x35mm)(42) for the PULLEY SET(26) on each side may need to be loosened to allow the REAR COVER(8) to fit securely over the frame. Refer to the inset illustration. When retightening the screws for the PULLEY SETS(26) do not over tighten. The PULLEY SETS(26) should swivel freely.

STEP 5

Insert the FOAM PAD ASSEMBLIES(21) into the holes located on the CARRIAGE(12).

Image 8

Contents This Product is Produced Exclusively by 2040 N. Alliance, Springfield, MOTable of Contents Safety InstructionsCall Us First Before YOU Begin AeroPilates Home StudioFront Cover Combination Wrench Socket WrenchEquipment Warning & Notice Labels Hardware Identification Chart 100 110 120 130 140 150Assembly Instructions StepAssembly Instructions Assembly Instructions Load Adjustment Operational InstructionsHome Studio MaintenanceStorage Conditioning Guidelines WARM-UP and COOL-DOWN Product Parts Drawing Parts List PART# Part Name QTYPart Name QTY Limited Warranty WarrantyPage FAX/MAIL Ordering Form Stamina Products, Inc Box Springfield, MO