Rope Length Adjustment

OPERATIONAL INSTRUCTIONS

LOAD ADJUSTMENT

The resistance of the CARRIAGE(7) can be adjusted by securing the TENSION CORDS(10) in the slots on the FRONT FRAME(1). You can achieve various levels of resistance by securing different numbers of the TENSION CORDS(10) in the slots.

NOTE: Over time your TENSION CORDS(10) will relax. To increase resistance in the TENSION CORDS(10), stretch and re-tie the tension cords in a more taut position.

Slots

The ROPES(18) feed through the PULLEY SETS(22) then thread through the loops on the underside of both outer edges of the CARRIAGE(7). PLASTIC SNAP HOOKS(19) on the end of each rope are used to adjust the ROPE(18) length. If more length is needed, attach the PLASTIC SNAP HOOKS

(19)to loop D. To shorten, bring the ROPES(18) around the last loop D and secure to loops A, B, or C with the PLASTIC

SNAP HOOKS(19). Wrap ROPES(18) through the loops and attach where needed to shorten ROPES(18) even more.

HEADREST ADJUSTMENT

The HEADREST(14) on the CARRIAGE(7) can be positioned flat or at an incline by simply pivoting the support bracket underneath the HEADREST(14).

WARNING:

Always ensure that the HEADREST(14) and support bracket are correctly positioned before use.

Support

Bracket