Stamina Products 55-4700A owner manual Assembly Instructions

Page 8

ASSEMBLY INSTRUCTIONS

STEP 2

Remove your AeroPilates Premier Studio from its packaging, placing the product on its side with the LOCKING PIN(69) side upward. Remove the LOCKING PIN(69) and unfold the MAIN FRAME ASSEMBLY separating the half that has the attached LOCKING PIN(69). When completed, the frame should form a “V” with the frame ends separated approximately three feet.

STEP 3

Attach the four RUBBER FEET(28) to the FRONT FRAME(1) and REAR FRAME(2) with ROUND HEAD SCREWS(M5x0.8x25mm)(38). Attach the WHEELS(27) to the FRONT FRAME(1) with WASHERS(M8) (47) and NYLOCK NUTS(M8x1.25)(42).

STEP 4

Unfold your AeroPilates Premier Studio to a flat position by moving the FRONT FRAME(1) away from the platform end of the product in a clockwise position until fully extended.

8

Image 8
Contents Owner’s Manual Table of Contents Safety InstructionsCall US First Before YOU Begin AeroPilates Premier StudioEquipment WARNING, Caution & Notice Labels Hardware Identification Chart Assembly Instructions StepAssembly Instructions Assembly Instructions Rear Stand Headrest Adjustment Operational Instructions Load AdjustmentRope Length Adjustment Storage Operational Instructions Headpad Adjustment and USEMaintenance Conditioning Guidelines WARM-UP and COOL-DOWN Limited Warranty Product Parts Drawing Parts List DIAGRAM# Part Name QTYParts List FAX/MAIL Ordering Form Stamina Products, Inc Box Springfield, MO