ASSEMBLY INSTRUCTIONS
(50) Rear Stand |
( Narrower ) |
SLOTS |
(48) Front Stand |
( Wider ) |
STEP 9
Insert the FOAM PAD ASSEMBLIES(14) into the holes located on the CARRIAGE(63). Place the HAND STRAPS(17) onto the FOAM PAD ASSEMBLIES(14) for storage.
STEP 10
To prevent the CARRIAGE(63) from moving while placing the AeroPilates 
onto its Stand, attach one of the TENSION CORDS(9) in the slots on the FRONT FRAME(1). Refer to the inset drawing. Place the AeroPilates 
onto the Stand as shown in the illustration.
NOTE: The rubber feet of the AeroPilates 
must fit into the FRONT STAND(48) and the REAR STAND(50). The FRONT STAND(48) is wider than the REAR STAND(50). The Foot Rest end of your AeroPilates 
will fit into the top of the FRONT STAND(48) and the Headrest end of your AeroPilates 
will fit into the REAR STAND(50).
10