Assembly Instructions

STEP 2

Remove your AeroPilates from its packaging, placing the product on its side with the LOCKING PIN(71) side upward. Remove the LOCKING PIN(71) and unfold the MAIN FRAME ASSEMBLY separating the half that has the attached LOCKING PIN(71). When completed, the frame should form a “V” with the frame ends separated approximately three feet.

STEP 3

Attach the four RUBBER FEET(25) to the FRONT FRAME(1) and REAR FRAME(2) with SCREWS (M5x0.8x25mm)(35). Attach the PLASTIC WHEELS(24) onto the FRONT FRAME(1) with WASHERS(M8) (42) and NYLOCK NUTS(M8x1.25)(38).

STEP 4

Unfold your AeroPilates to a flat position by moving the FRONT FRAME(1) away from the platform end of the product in a clockwise position until fully extended.