Assembly Instructions

STEP 2

Remove the paper covering from the foam tape inside the FRONT COVER(7) and REAR COVER(8). Place the FRONT COVER(7) over the FRONT FRAME(1). Press the FRONT COVER(7) securely in place. Place the REAR COVER(8) over the REAR FRAME(2). Press the REAR COVER(8) securely in place.

NOTE: The securing SCREWS(M6 x 35mm)(37) for the PULLEY ASSEMBLY(22) on each side may need to be loosened to allow the REAR COVER(8) to fit securely over the frame. Refer to illustration. When retightening the screws for the PULLEY ASSEMBLY(22) do not over tighten. The PULLEY ASSEMBLY(22) should move freely.

STEP 3

Insert the FOOT REST(9) into the mounting holes located on the FRONT FRAME(1). The FOOT REST(9) should pass through the FRONT COVER(7) and the FRONT FRAME(1).

STEP 4

Insert the FOAM PAD ASSEMBLIES(17) into the holes located on the CUSHION ASSEMBLY(10).