Vector VEC128BW, VEC128Y, VEC128R owner manual Contents, Safe Battery Disposal, Specifications

Page 2

 

 

CONTENTS

 

1.

INTRODUCTION

. .1

2.

FEATURES

1,2

3.

OPERATION

. .2

4.

RECHARGE

. .2

 

4.1

AC Recharge

. .3

 

4.2

DC Recharge

. .3

5.

MAINTENANCE/PARTS REPLACEMENT

.3

6.

SPOTLIGHT BULB REPLACEMENT

.4

 

6.1

SPOTLIGHT Bulb Removal

. .4

 

6.2

Spotlight Bulb Installation

. .4

7. LANTERN TUBE REPLACEMENT . . . . . . . . . . . . . . . . . . . . . .5

7.1 Fluorescent Tube Removal . . . . . . . . . . . . . . . . . . . . . . .5

7.2 Fluorescent Tube Installation . . . . . . . . . . . . . . . . . . . . . .6

8. FUSE REPLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6

9. BATTERY REPLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . .6,7

9.1 Battery Removal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

9.2 Battery Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

10. SAFE BATTERY DISPOSAL . . . . . . . . . . . . . . . . . . . . . . . . . .7

11. SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8

WARRANTIES

CAUTIONS:

DO NOT SUBMERGE IN WATER. This unit is not waterproof— it is water resistant.

Do not recharge with other than supplied AC and DC Recharge Adapters.

Do not overcharge battery.

Do not operate lights while AC recharging—this can damage the AC recharger.

This spotlight produces high levels of heat when operating—DO NOT TOUCH THE SPOTLIGHT LENS WHEN THE SPOTLIGHT IS ON.

Keep spotlight lens away from combustible materials when spotlight is On.

This light is not a toy—keep away from children.

9.1 BATTERY REMOVAL PROCEDURE

1.Press the tab on the lower part of the Battery Compartment Cover while lifting the cover.

2.Fully remove the cover and set it aside.

3.Carefully move the battery towards the opening of the compartment.

4.Using a long nose pliers, carefully rock each spade terminal and remove them from the Battery Spade Lug Terminals. Note the colors of the attached wires and which terminal they were connected to.

5.Fully remove the battery and set it aside.

6.Follow Safe Battery Disposal instructions

9.2 BATTERY INSTALLATION PROCEDURE

1.Partially insert the new battery in the compartment in the same position as the old battery was.

2.Using the long nose pliers, attach the Spade Connectors to their respective Battery Spade Terminals. Check to ensure they are fully connected.

3.Push battery back into compartment.

4.Replace cover and slide downward until the tab snaps into place.

5.Momentarily check operation of the spotlight and lantern for proper operation.

6.Recharge the battery using either the AC or DC Recharge Adapter.

10.SAFE BATTERY DISPOSAL

Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be disposed of properly. Recycling is required; contact your local authority for information. Failure to comply with local, state and federal regulations can result in fines or imprisonment. Sealed lead batteries must be recycled or disposed of properly. Most automotive battery retailers will accept any lead- acid battery for recycling.

BATTERY DISPOSAL WARNINGS

Do not dispose of the battery in fire as this may result in an explosion.

Before disposing the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result in injury or fire).

Do not expose battery to fire or intense heat as it may explode.

11.SPECIFICATIONS

Spotlight Bulb . . . . . . . . . . . . . . . . . . .H-3 Series, 12 volt, proprietary Lantern Tube . . . . . . . . . . . . . . . . . . .9 Watt, Fluorescent, proprietary Battery . . . .Maintenance free, sealed lead acid 12 volt, 2.5 Amp Hour Fuse . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10 Ampere Weight. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3.6 lbs. (1.63 kg) Dimensions

SPOTLIGHT POSITION

13.5" H X 7.5" D X 5.5" W

. . . . . . . . . . . . . . . . . . . . . . . . . . . .(3.42 mm x 1.9 mm x 1.4 mm)

LANTERN POSITION

11.2" H X 8" D X 5.5" W

. . . . . . . . . . . . . . . . . . . . . . . . . . .(2.85 mm x 2.03 mm x 1.4 mm)

7

Image 2
Contents Patent Pending WarrantiesFT. LAUDERDALE, FL Specifications ContentsSafe Battery Disposal Introduction Fuse ReplacementBattery Replacement Operation FeaturesLantern Tube Replacement RechargeMAINTENANCE/PARTS Replacement Spotlight Bulb Replacement