Important Things You Should Know
r Carefully inspect the pump for damage before first use and every use thereafter. Do not use if found damaged.
r Keep unit out of reach of children.
r Do not expose to rain or sunlight. Household use only.
Warnings
r Follow the instructions carefully on articles to be inflated, never exceed recommended pressure. Bursting items can cause serious injury.
r Do not open case, electrical hazards may result. There are no user serviceable parts.
r Do not use under wet conditions. Keep away from water.
r Do not use or place near heaters, open flame or other hot objects.
r Never look into or point any opening toward your eyes while pump is operating.
r Do not attempt to put any objects into the inflation or deflation port at any time.
r Never leave pump unattended while in use.
r Never allow sand, paper, debris or small articles to be sucked
To Install Or Replace Batteries
Your new pump operates on 4 “D” cell batteries. For longest life, use alkaline batteries.
1.With pump off, press two release tabs to remove 4D battery pack. (Fig. 1)
2.Press snap feature to open the 4D battery pack top cover. (Fig. 2)
3.Install 4 batteries in the correct orientation as shown on the battery housing. Always be careful that all 4 batteries are installed correctly. (Fig. 3)
4.Close top cover and install 4D battery pack properly into the pump. (Fig. 4)
Fig. 1 |
Parts List
1.5010000712
4D (6V) Battery Pack
1
Alternative Power Sources For This Product
r 2000002672
6V NiMH Rechargeable Battery Pack
r 2000003287
6V Sealed Lead Acid Rechargeable Battery Pack
Note: To order an alternative power source for this product, please go to www.coleman.com or call Coleman Customer Service.
Double Lock™ Valve Operation
To Open Valve
Open - Step 1: | Open - Step 2: |
Pull to Open
| Internal |
| Yellow |
| Post |
Internal Seal Closed | Fully Opened Valve |
Pull open cap. | Firmly pull cap to unseat valve from |
| inner yellow post. |
To Close Valve
Push to Close 
into pump while operating.
t DO NOT BLOCK THE AIR VENTS DURING OPERATION, THIS COULD DAMAGE THE MOTOR.
Fig. 2 |
Fig. 3 |
Internal Seal Closed | Fully closed Valve |
Reverse Steps 1 & 2. Make sure valve | Close cap. |
seats on inner yellow post. |
|
Fig. 4 |
CAUTION: Air temperature and weather do affect the air pressure in inflatable products. In cold weather your airbed will lose some pressure due to the fact that the air will contract.
If this occurs, you may want to add a little air to improve your airbed’s performance. However, in hot weather, the air will expand. You must let some air out to prevent the airbed from failing due to overpressure. You should avoid exposing your airbed to extreme temperatures (hot or cold).
Note: For optimum performance, alkaline
batteries are recommended.