HOLIDAY DOME TENT 12’ X 10’
Before you begin
Read all instructions before set up.
•Select a level campsite clear of rocks, branches, and other hard or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
•Do not set up your tent under trees.
•For best results in windy conditions, position end of tent into the wind.
•Enlist the help of at least one other person to assist you when it is time to assemble the tent.
MODEL 2000001080
Parts and Components
Description | Part Number |
Main Poles, Long, Black (2) | 5010000364 |
Rainfly Awning Pole, Thin, Black (1) | 5010000365 |
Rainfly | 5010000366 |
To Set Up Tent
1.Unfold tent and spread out on a clean, level surface with the door facing the desired direction. (Fig. 1)
2. Assemble two main tent poles by interlocking the longer, black
3. Insert both, long, black poles through sleeves in top of tent as shown. (Fig. 1)
Fig. 1
Long, Black,
Main Poles
Door
STITCH LINE
4. Insert one end of each black pole | Fig. 2 |
into pins in front corners of tent. |
|
| |
(Fig. 2) |
|
5.Go to opposite end of each pole and gradually apply pressure to the pole forming an arch. Insert the pin into the pole end at the corners of tent. (Fig. 3)
6.Attach frame clips along edges of tent to black main poles. (Fig. 3A)
7.Stretch corners and sides of tent until floor is taut then hammer stakes through loops to secure. (Fig. 3B)
3B
3A | Fig. 3 |
|
|
To Attach Rainfly
1.Assemble longer interlocking
2.Unfold rainfly. Locate the sleeve, along front edge, and the hook & loop fasteners on the underside of rainfly.
3.Drape rainfly over tent. Make sure the sleeve is centered over the door and the hook & loop fasteners, on the underside of the rain fly, are positioned over the black
main poles.
4.Clip hooks on elastic cords, on the back corners of rainfly, onto metal loops at back corners of tent.
(Fig. 4A)
5. Slide rainfly pole through sleeve at front of the flap. (Fig. 4)
Door
3A
(continued on other side)