ASSEMBLY INSTRUCTIONS
BEFORE ATTEMPTING TO USE THIS PRODUCT ON THE ICE practice setting up and taking down at home in the comfort of a heated area. Repeat several times until comfortable. This will make your
NO TOOLS ARE NEEDED FOR ASSEMBLY OF YOUR CLAM 5600.
1.INITIAL
a.Open the Clam 5600 and lay on a flat level surface. See Diagram A.
b.Lift up the two hoop pole sections until the snap button locks into place. Lock the braces. See Diagram B. (Both ends.)
c.Unfold the tent and unzip both doors. Pull the tent over the two hoop poles. See Diagram C.
d.On the door ends of the tent on the top of the seam, you will see two velcro strips. Attach the two velcro strips to the two hoop poles on the top of doors.
2.INSERT POLES
a.Insert the two spreader tubes (#6) on each end of the hoop pole. See Diagram D.
b.Adjust the spreader tubes until the hoop poles are at a 90 degree angle and tent is snug, then tighten the adjustment knob.
c.Install the dome pole (#21) in the center of the 5600. See Diagram E. (Note: The dome pole is
the
3.FASTEN THE TENT
a.Fasten the tent to the base by placing the elastic straps around the notches in the base.
See Diagram F.
b.Continue fastening the tent to the base by inserting the strap from the tent through the back of the buckle. See Diagram G. Pull the strap until the elastic on the buckle starts to stretch. Fold the tab on the buckle over and all the way down to fasten. See Diagram H. (Note: This
only needs to be done the first time you set up your 5600.)
4.INSTALL LICENSE (Check with local authorities for the requirements of your area.).
a.Locate the clear sleeve sewn to the outside of the tent. Slide the required documention of you area into the sleeve for display.
Page 6