Symptom | Probable Cause | Corrective Action | Recommended Tools |
HEART RATE
NOT
WORKING /
ERRATIC
READINGS
Incorrect power
source
Improper treadmill
grounding
Improper heart rate
receiver mount
Defective Chest
Strap
Defective receiver
Radio Frequency
Interference
•Verify that the treadmill is connected to a dedicated line,
•Move to proper outlet.
•Test 110 VAC outlet for proper ground
•Proper grounding is vitally important.
•Ensure that the pedestal wire harness ground lead is secure
•Ensure that the HR receiver is not touching metal and is mounted with the wires in a vertical position with the blue receiver facing the runner
•Does the receiver pick up a signal from the HR simulator?
•If yes, replace chest strap
•Does the heart rate LED on the control panel blink? If not then replace the receiver.
•Locate RF sources and use process of elimination. Common sources of RF interference are: Invisible fences for pets; wireless networks; cordless phones, Cell phones, radios, home security sensors, etc.
Double sided tape
Heart rate simulator
Note:
All trouble shooting should be performed in calibration mode.
Page 14
Page 8
Support Services | Fax: | |
|
|
|