Once you have tested your system and have confirmed that it is operating properly, turn off your system and prepare for the final mounting of the speakers.
1.Position the speaker into the mounting hole and reconfirm the correct mounting location and hole placement. Screw clips are provided to insure a snug fit. Place screw clips over the metal surface and line up the hole with the hole you have previously drilled. Place the speaker into the hole, align the mounting holes and proceed to insert the screws. Be sure to tighten the screws evenly as to not warp the speaker frame.
2.Turn your system back on and confirm the speaker's operation, first at low volume and then you may increase the volume as you desire.
3.The next steps will aid in the proper mounting of the speaker grilles. Follow these steps carefully and be patient. First, locate the special bonding rubber which is located between the waxed paper in the hardware package.
4.Carefully inspect the mounting ring where the grill will be inserted. You will notice 4 to 6 channeled areas. This is the area where the bonding rubber will secure the grill to the speaker.
5.Break off pieces of the bonding rubber that correspond to the size of the channels and insert it snugly in place. Once all of the channels have been filled, carefully insert the grille and press it firmly into place.
I
N
S T A L L A T I O N
C O N T I N U E D
8