3.Press the DIRECTIONAL KEY PAD again to locate the desired base.
4.Press the A key to throw the ball to that base.
DEFINITION OF TERMS PITCHER SELECT: Indicates that you are pitching and asks you to select a pitch location. BATTER SELECT: Indicates that you are batting and to select a pitch location.
HIT: occurs when the batter hits the ball.
SAFE: the ball falls on the fi eld and the batter successfully runs to the base.
OUT: the batter is out.
STRIKE: occurs when the batter misses a pitch or lets a pitch go by within the strike zone.
BALL: the batter lets a pitch go by outside of the strike zone. FOUL: the ball falls outside of the designated fi eld area. HOME RUN: the batter hits the ball over the outfi eld fence within the designated fi eld area.
DEAD BALL: occurs when the batter is hit by a pitch.
TAKE ONE BASE: occurs when a batter is hit by the pitch, or when 4 BALLS are accumulated.
FLYBALL : a ball caught in mid ai r
TEAM REPLACE: teams exchange positions after each half inning.
NOTE: The umpire gives hand signals for STRIKE OUT SAFE , and HOME RUN
SCORING
•Each inning has two halves.
•Each half ends when the batter has 3 outs, or when a team scores 39 runs.
•One run is scored wihen a base runner crosses home plate.
TWO-PLAYER MODE
1.Make sure both units are turned off.
2. Connect both units with the
3.Press the ON/OFF key to turn the units on.
4.Press START on either of the two units to start the
game.
5.Follow the directions for 1- player mode from this point.
7