Battery Installation

Battery Housing

Controllers

SET UP

101-In-1 Action Games Plug and Play

Carefully open the casing on the battery housing. This is done by using the tab on the side of the unit. Once open, install 4 AA batteries into the unit, making sure to match the polarity of each battery as shown in the diagram inside the battery compartment. Once complete, firmly close the battery compartment.

Gently lay the controllers face down. Underneath is the battery compartment. With a small Phillips head screw driver, unscrew the battery compartment housing. Insert 3

AAbatteries (each controller), making sure to match the polarities as indicated on the inside of the battery compartment. Replace the cover and screw on tightly.

The Infrared (IR) receiver should go on top of the TV so that it receives a clear signal from the controller units. Use the stick pad on the bottom of the receiver to stick it firmly in place. Remove the protective layer from the stick pad and then press the receiver firmly down onto your TV.

Take the RCA cables (these are the white and yellow plugs that are connected to the IR) and plug them into the corresponding slots on the back (or sometimes front) of your TV. Lay the battery housing on a flat surface and you have completed connecting the 101-in-1 Action Games Plug and Play system.

Infrared

Receiver

Battery

Housing

Quick Set Up:

1.Follow the instructions for installing batteries.

2.Remove stick pad from IR sensor and firmly press it to the top of your TV.

3.Connect the yellow and white RCA cables into the corresponding plugs on your TV.

4.Flip the switch on the battery housing to the ON position

5.Turn on the controller units and you are ready to play!

4	5