SYSTEM OPERATION
SYSTEM OPERATION
TO BEGIN PLAY
•Make sure the unit is turned OFF.
•Press the 
EJECT button to open the Main Unit cover.
•Place the V.DISC™, label and printed side up, into the disc compartment and onto the center hub.
•Close the Main Unit cover.
•Turn your TV on.
•Set your TV input mode to accept input from the port to which V.FLASHTM is connected. In many cases this will involve setting the TV to “ video” mode; however, since all TVs vary, please refer to your TV or VCR manual for further details.
•Make sure that both the Controller and AC adaptor are properly plugged into the console and the wall outlet.
•Turn the V.FLASHTM Home Edutainment System on by pressing the 
ON button. Enjoy your game!
•When not using your V.FLASHTM, press the 
OFF button and 
EJECT button to remove the V.DISC™.
•Close the Main Unit cover.
NOTE:
•If you don’t see the V.FLASHTM logo screen on your TV, please review the above. If there is still no picture on TV, press the RESTART button and wait for a few seconds then press ON button again. Please refer to Troubleshooting table for more information.
•Do not accidentally press the RESTART button while playing a game, or the game will restart.
TO CHANGE A V.DISC™
•While the power is ON, press the 
OFF button to stop the game play.
•Press the 
EJECT button to open the Main Unit cover and remove the V.DISC™ from the console.
•Place another V.DISC™, label and printed side up, into the disc compartment and onto the center hub.
•Close the Main Unit cover.
•Press the 
ON button and start to play.
7