Mode I - Beginner Driver
Let’s Go
Reset Switch
ON/OFF
Button
IMPORTANT! Be sure the plugs on each end of the track are fully inserted into the sides
of the control tower.
•Slide the reset switch on the
back of the control tower to the ON position 
.
•Press the ON/OFF button on the front of the control tower.
The button will be brightly
lit 
if the track is properly connected!
Hint: If the car has not driven past the control tower in a few minutes, the control tower turns off automatically and the control tower button light goes out. Press the ON/OFF button again for power in the control tower and track.
Mode Switch
On/Off
Button
Speed Control Switch
•Slide the mode switch on top of the car to I for beginner driver mode.
•Locate the speed control switch on the bottom of the car.
•Slide the switch to either slow
speed 
or fast speed 
.
Hint: We recommend slow speed for first time drivers.
•Press the ON/OFF button on top of the car to turn the car on. The car button lights up. The car is now ready to receive a signal from the remote controller.
Hint: If the car has not been driven for a few minutes, it turns off automatically. Press the ON/OFF button again for power in the car.
12