Miller Electric Elitet, XLix manual Battery Replacement, XLi and Xlix

SECTION 4 − BATTERY REPLACEMENT

XLi and Xlix –

Remove the battery by inserting a coin into the slot on the battery cover and turn to the left to release the cover. Replace with a CR2450 lithium type battery or equivalent, Miller Part No. 217043. (Note: make certain that the positive, (+) side of the battery faces up when reinstalling). To rein- stall battery cap, position cap with arrows at 6 and 12 o’clock positions then turn cap 1/4 turn clockwise.

Elite −

To replace the batteries on the Elite remove the auto-darkening lens assembly. Please refer to the procedure found in the lens cover replace- ment section. After removing the lens assembly, locate the two battery compartments located on the bottom. Slide the battery holding trays out and remove the old batteries. Replace with CR2450 lithium type batteries or equivalent, Miller Part No. 217043. (Note: make certain that the posi- tive, (+) side of the battery faces up). Reinstall the battery trays. To test, press the On or Reset button. The lens should flash dark twice. Reinstall the lens assembly.

.Left and right battery trays are not interchangeable. The auto−darkening helmet will not work if battery trays are installed on the wrong sides.

OR

Manual-On Lens

Left	Right
Battery Tray	Battery Tray
Auto-On Lens	804 090

Page 10