S T E P 4 AUTO-CALIBRATION
Once the treadmill is plugged in, you need to perform an Auto-Calibration to assure maximum performance.
MODELS T9350HRT & T9450HRT:
DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION
•You need to access User Engineering Mode to run the Auto-Calibration. With the Safety Key in place, please hold down SPEED DOWN and SELECT for 5 seconds. When in the User mode, "USEr" displays in the center window. To access the data press the ELEVATION keys until "Auto" appears in the center window. Press Start to select this function.
•To begin Auto-Calibration, press START. The treadmill will run through minimum and maximum Speed and maximum Elevation. This will take 3-5 minutes. Let the treadmill perform this complete function before exiting the Engineering Mode.
•Elevation A/D or Elevation in % appears in the left window. PWM value or Speed appears in the right window. "End" will appear in the center window when the Auto-Calibration is complete. When Auto-Calibration is complete, it will take the treadmill about 30 seconds to go to 0% Elevation and return to the start-up screen with “P1” showing in the Function window.
MODEL T9250:
DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION
•With the Safety Key in place, hold the ELEVATION UP and SPEED DOWN buttons for 5 seconds. The console will beep 5 times and a number will appear in the window. Shortly thereafter, “EnG1” will appear in the window. Press the ELEVATION UP or SPEED UP to “EnG4.”
•Press START. The treadmill will Auto-Calibration itself. It will take 3-5 minutes. When the Auto-Calibration is complete "END" will flash in the window. Wait 10 seconds.
•Remove the Safety Key. Then, put the Safety Key in place to use the treadmill.
