JVC UX-L30 Playing Back Tapes, Playing Back a Tape, Press 0 Push Open on the unit, Press Tape 2

Playing Back Tapes

You can play back type I, type II, and type IV tapes without changing any settings.

Playing Back a Tape

1 Press 0 PUSH OPEN on the unit.

0 OPENPUSH

To stop playing, press 7.

To fast-wind to the left or to the right, press ¢ or 4

while the tape is not running.

The tape direction indicator (3 or 2) starts flashing quickly on the display.

To remove the cassette, press 0 PUSH OPEN on the unit.

To play both sides—Reverse Mode

You can set the deck to play just one side of a tape, both sides once, or both sides continuously.

REV.MODE

Press REV.MODE.

•Each time you press the button, reverse mode changes as follows:

REV. MODE

2

3

Put a cassette in with the exposed part of the tape down.

Press 0 PUSH OPEN again.

: The deck automatically stops after playing both sides of the tape. Stops when playback in the 2 direction is finished.

: The deck continues to play both sides of the tape until 7 is pressed.

: The deck automatically stops after playing one side of the tape.

The use of the C-120 or thinner tape is not recommended, since characteristic deterioration may occur and this tape easily jams in the pinch- rollers and the capstans.

4 Press TAPE 2 3.

The unit automatically turns on and the tape starts playing. The tape direction indicator (3 or 2) flashes slowly on the display.

•Each time you press the button, the tape direction changes.

3 : plays the front side.

2 : plays the reverse side.

23

TAPE

TAPE

When the tape plays to the end, the deck automatically

stops if the reverse mode is set to or . (See “To play both sides—Reverse Mode.”)

If no cassette is inserted

“NO TAPE” appears on the display.

– 16 –