JVC UX-L30 Listening to FM and AM MW/LW Broadcasts, Tuning in to a Station, Presetting Stations

Listening to FM and AM (MW/LW) Broadcasts

Tuning in to a Station

1 Press FM/AM to select the band. FM/AM

The unit automatically turns on and tunes in to the previously received station (either FM or AM—MW/LW).

Presetting Stations

You can preset 30 FM and 15 AM (MW/LW) stations—

using either automatic presetting or manual presetting.

In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction.

• Each time you press the button, the band alternates between FM and AM (MW/LW).

FM/AM

You can preset the stations you want into memory by following the presetting method.

To preset stations automatically—Automatic Presetting

You need to preset stations separately for the FM and AM

2 Press and hold ¢ or 4			4	¢
for more than 1 second.
The unit starts searching for stations
and stops when a station of
sufficient signal strength is		DOWN		UP
tuned in.
If a program is broadcast in
stereo, the ST (stereo)
indicator lights up.
To stop searching, press ¢ or 4.
	When you press ¢ or 4 briefly and repeatedly
The frequency changes step by step.
To change the FM reception mode
On the remote control ONLY:
When an FM stereo broadcast is hard to receive or				FM MODE
noisy, press FM MODE so that the MONO
indicator lights up on the display. Reception
improves.

MONO

To restore the stereo effect, press FM MODE again so that the MONO indicator goes off. In this stereo mode, you can hear stereo sounds when a program is broadcasted.

(MW/LW) bands.

On the remote control ONLY:

1 Press FM/AM to select the band you	FM/AM
want to preset.

2	Press and hold AUTO PRESET for	AUTO
		PRESET
	more than 2 seconds.
	Local stations with strong signals are searched
	and stored in memory automatically.
	When automatic presetting is over, the station
	stored in preset number 1 is received.

3 Repeat steps 1 and 2 to store stations for the other band.

•When you cannot automatically store stations you want Stations with weak signals cannot be detected with this automatic presetting. To store such a station, use the manual presetting.

•When you unplug the AC power cord or if a power failure occurs

Preset stations with the automatic presetting are erased at once. If this happens, preset the stations again.

– 11 –