Keys Fitness owner manual Program and Operating Instructions, Program MODE-FOR the HT500

Program and Operating Instructions

PROGRAM MODE-FOR THE HT500

♦Plug treadmill into a surge protector outlet . Attach RED Safety Key to treadmill console.

♦Stand on the treadmill and straddle belt. Attach safety key clip to your clothes.

♦Press POWER button. There will be an eight (8) second delay before data can be entered. The TIME window will flash.

♦There are three (3) pre-set and six (6) custom pre-set programs on the DCV100. The treadmill includes FAT BURN, CARDIO, and WARM-UP programs. To select the program press the MODE button until desired program is illuminated on console display.

♦Each of the pre-set programs can also be customized for your particular workout.

♦CUSTOMIZING PROGRAMS in P1 and P2 Mode: Each pre-set program(Fat Burn, Cardio, Warm- up) can be customized in the P1 or P2 mode. After making the program selection, the CAL/DIST window will read “OP.” The ”OP” refers to “original program” and is preset. The program you select will illuminate on console display. Press the MODE button once more and the CAL/DIST window will read P1. The “P1” mode is now accessed. You can now program the Time, Speed, and Incline in P1 mode, which will be saved for future workouts.

1) The TIME window will blink. Use the SPEED/TIME + or – arrows to select your workout time.

Press ENTER PROGRAM.

2) The SPEED window will then blink. Use the same + or – arrows to select the speed for your workout. Press ENTER PROGRAM.

3) The INCLINE window will then blink. Use the INCLINE + or – arrows to set your workout incline. Press ENTER PROGRAM.

To start, press the START/STOP button. To access P2 mode, press the MODE button for desired pro- gram, then press the MODE button again (once for OP, twice for P1, three times for P2). Follow the above steps 1-3 to customize P2 settings.

♦TO CHANGE A PREVIOUSLY PROGRAMMED P1 or P2: Once you have programmed the P1 or P2 modes, you will need to use the PAUSE button to change the program you previously entered. For instance to change to a new setting in P1-FAT BURN, press the MODE button to reach the FAT BURN program, then once to access P1. Then press the PAUSE button to get the TIME window to flash. Follow the directions above to continue to change the program.

	CARDIO
		WARM UP
FAT BURN

ENTER

MODE

POWER

RED SAFTEY KEY HOLDER PAGE 11 PAUSE START/STOP