JVC Model MX-J70J manual Using Recording Timer

Continued

6 When selecting “– CD – – –”

1)Press 4or ¢ to select the disc number, then press SET.

2)Press 4or ¢ to set the track number, then press SET.

The unit enters volume setting mode.

When selecting “TUNER FM” or “TUNER AM”

Press 4 or ¢ to select the preset station number, then press SET.

The unit enters volume setting mode.

7 Press 4or ¢to set the volume level.

PRESET

SEA CONTROL

SET

PRESET

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically.

How Recording Timer actually works

The unit automatically turns on, tunes into the specified station, sets the volume level to “0,” and starts recording

when the on-time comes (the indicator flashes just before the on-time, and continues flashing while the timer is operating). Then, when the off-time comes (“OFF” appears just before the off-time), the unit automatically turns off (stands by).

The timer setting remains in memory until you change it.

• There is a time limit in doing the following steps. If the

	• You can select the volume level from among
	four levels. If you select “ VOL – – –,” the volume is
	set to the last level when the unit has been turned off.
		DAILY
8			SEA CONTROL
	Press SET to complete the Daily
			SET

Timer setting.

The DAILY indicator stops flashing and

remains lit. The settings you have done are shown on the display in sequence.

STANDBY

9 Press POWER to turn off the unit

(on standby) if you have set the Daily	POWER
Timer with the unit turned on.

To turn on or off Daily Timer after its setting is done

setting is canceled before you finish, start from step 1

again.

• If you have made a mistake while setting the timer, press

CANCEL. (However, this does not always work. If

CANCEL does not work, press TIMER/CLOCK repeatedly

and start from step 1 again.)

On the unit ONLY:

1 Put a recordable cassette into deck B.

2 Press TIMER/CLOCK until “REC”

TIMER

appears on the display. /CLOCK

The REC indicator also starts flashing on the display.

REC

1Press TIMER/CLOCK repeatedly until “DAILY” appears on the display.

2 To turn off the Daily Timer, press CANCEL.	TIMER
	/CLOCK
The DAILY indicator goes off from the display.
The Daily Timer is canceled, but the setting for
the Daily Timer remains in memory.	DEMO
	CANCEL

•Each time you press the button, the timer setting modes change as follows:

DAILY ON TIME REC

Canceled Clock ON TIME setting

(See page 10.)

To turn on the Daily Timer, press SET.		3 Press TIMER/CLOCK again.	TIMER
The DAILY indicator lights up on the display.		“ON TIME” appears for 2 seconds, then the	/CLOCK
The settings you have done are shown on the	SEA CONTROL
	SET	unit enters on-time setting mode.
display in sequence for your confirmation.

REC

If the unit is turned on when the timer-on time comes

Daily Timer does not work.

REC

– 24 –

EN20-28.MX-J70[J]/f 24 99.2.9, 1:34 PM