HoMedics Steamer Nozzle Handle Hanger Attachment Hose Pole, PS-200C1/27/05 1032 AM Page

PS-200C 1/27/05 10:32 AM Page 7

Instructions for Use

		1.				Remove the water tank from the unit by grasping the handle and
						turn upside down. Unscrew the cap from the bottom of the water
						tank. Hold the tank under cold running water and fill to the
						desired level (Fig. 5). DO NOT fill past the 40 min. fill line. When
						you have finished filling the tank screw the cap back on and turn
						over (Fig. 6). Place water tank back into unit and make sure it is
						sitting properly & securely in the cavity. NOTE: Only fill the water
Figure 5				2.		tank with cold water, DO NOT use HOT water.
						Plug the steamer cord into a 120V AC electrical outlet.
				3.		Turn the On/Off switch to the On position. The switch will light to
						indicate that the garment steamer is on. Steam will emit in 45
						seconds from the nozzle.
		4.				This unit has a reset button (Fig. 9). When the unit runs out of
						water it will automatically shut-off to ensure safe use and a red
						indicator light will come on (above reset button). If you wish to
						continue your steaming session:
	Figure 6					• Turn On/Off switch to “Off” position
						• Remove and refill water tank by following step 1 under
						Instructions for Use
						• Push the reset button on side of unit
						• Turn On/Off switch to “On” position
		5.				When you are finished with your steaming session place the
						On/Off switch in the Off position and remove the plug from the
						outlet.
					NOTE: Be cautious when handling until steamer has fully cooled.
	Figure 7				Cleaning and Maintenance
		1.				Allow the steamer to cool for at least 30 minutes.
		2.				Empty any excess water from the water tank and allow it to air dry
						before replacing the cap and setting it back in the unit.
		3.				Empty excess water from the reservoir by removing the drain plug
						(Fig. 7) and tipping unit.
					Storing
		1.				Open the 3 clips (Fig. 2) on the telescopic pole and glide it slowly
						to collapse being careful not to pinch your fingers. When it is all
						the way down close the 3 clips back into place.
		2.				Coil the hose and place on the hanger attachment (Fig. 8)
			3.			Store in a cool, dry place.
Figure 8
					NOTE: Do not wrap the power cord around the unit.

Steamer Nozzle

Handle

Hanger Attachment

Hose

Pole

Pole Connector

Water Tank

Hose Connector

On/Off Switch

Indicator Light

& Reset Button

Figure 9

6 7