Image IMTL59105.0 user manual Troubleshooting, Problem The power turns off during use

Page 22

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call the toll-free telephone number on the front cover of this manual.

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 11). Use only a single-outlet surge suppres- sor that meets all of the specifications described on page 11. Important: The treadmill is not com- patible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c.Check the reset/off circuit breaker located on the treadmill frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes, and then press the switch back in.

PROBLEM: The power turns off during use

c

Tripped

Reset

SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the treadmill still will not run, see the front cover of this manual.

PROBLEM: The incline of the treadmill does not change correctly

SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline system.

PROBLEM: The display of the console does not function properly

SOLUTION: a. Remove the key from the console and UNPLUG THE POWER CORD. With the help of a second person, carefully tip the Uprights (13, 14) down as shown. Next, remove the three Screws (3) and the three Hood Screws (7). Note: A phillips screwdriver with a shaft at least 5” long is required.

a

3

7

14

 

 

 

 

3

 

 

13

 

 

3

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Call TOLL-FREE QUESTIONS?Model No. IMTL59105.0 Serial No Mon.-Fri., 6 a.m.-6 p.m. MSTTable of Contents Important Precautions Page Right Side Before YOU BeginBack Make sure that the power cord is unplugged AssemblyCutters Adjustable wrench Rubber mallet Fold the treadmill until it is completely assembledHarness 77 fall into the Right Upright Start all five Screws, but do not tighten them yet Screws used in and this step do not over- tighten the Screws Top ViewChest Pulse Sensor Care and Maintenance HOW to USE the Chest Pulse SensorHOW to PUT on the Chest Pulse Sensor Chest Pulse Sensor TroubleshootingHOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Trainer Programs Console DiagramFeatures of the Console Cardio Control ProgramsHOW to Turn on the Power HOW to USE the Manual ModeTurn on the fan if desired Measure your heart rate if desiredWhenkey. you are finished exercising, remove HOW to USE a Trainer Program Select one of the trainer programsSelect a cardio control program HOW to USE a Cardio Control ProgramPut on the chest pulse sensor If cardio control pro- gram 7 is selected, aIf cardio control pro- gram 8 is selected, Select the 10,000 steps program HOW to USE the Mytracks Step Counter ProgramWhen the program is completed, remove Key from the console Turn on the workout fan if desiredInformation MODE/DEMO Mode HOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useProblem The walking belt slows when walked on Top Problem The chest pulse sensor does not function properly Workout Guidelines Conditioning GuidelinesExercise Intensity Exercise FrequencySuggested Stretches R0805A Qty DescriptionExploded DRAWING-Model No. IMTL59105.0 7896 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT
Top Page Image Contents