ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrench | and your own phillips screwdriver | , wire | ||
cutters | , adjustable wrench | , and rubber mallet | . |
|
Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled.
Silver Ground |
| Screw | |
Screw | 1” Tek Screw | ||
Wheel Bolt |
|
|
|
| Handrail Star |
| Upright Star |
| Washer |
| |
|
| Washer | |
|
|
| |
Handrail Bolt |
|
|
|
Upright Bolt | Wheel Nut | Wheel Spacer | |
1. Make sure that the power cord is unplugged. | 1 |
| |
|
| ||
With the help of a second person, carefully tip the |
| 58 | |
44 | 84 | ||
treadmill onto its left side as shown. Partially fold the | |||
|
| ||
Frame (58) so the treadmill is more stable. Do not fully |
| 82 | |
fold the treadmill until it is completely assembled. | 83 | 82 | |
|
| ||
Press a Base Endcap (44) into the indicated end of the |
|
| |
Upright Base (84). Make sure that the Base Endcap is |
| 83 | |
oriented as shown in the inset drawing. If necessary, use |
| ||
a rubber mallet to insert the Base Endcap. |
|
| |
Attach two Base Pads (82) to the Upright Base (84) with |
|
| |
two 1” Tek Screws (83). |
|
| |
| 44 | 84 |
6