4.Hold the Console Base (47) near the Left Handrail (71). Attach the end of the ground wire on the Console Base to the indicated small hole in the Left Handrail with the Silver Ground Screw (75).
5.Touch the Right Handrail (72) to discharge any static. Slide the sleeve off the connector on the Upright Wire (42) as shown in the inset drawing. Next, press the end of the Upright Wire into the socket in the bottom of the Console Base (47). The connector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn the connec- tor and then insert it. Then, slide the sleeve back over the connector.
6.Set the Console Base (47) on the Handrails ( 71, 72). Attach the Console Base with four 3/4” Screws (2). Start all four Screws before tightening them; do not over- tighten the Screws.
See the lower drawing. Make sure that the Upright Wire
(42)is routed below the two indicated round posts (A). Next, press the Upright Wire into the slot between the square post (B) and the Console Base (47).
8
4 |
Ground |
Wire |
47 |
Small |
Hole |
75 |
71 |
5 |
72 |
47 |
42 |
| Sleeve | Connector |
42 |
|
|
6 |
| 47 |
|
| |
72 |
| 71 |
2 |
|
|
|
| 2 |
| A |
|
|
| B |
42 | 47 |
|