Assembly

To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own Phillips screwdriver

and needlenose pliers

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

For help identifying assembly hardware, see the drawings below.

5/16” Star	Wheel Nut (32)–2		Silver Ground Screw		2” Bolt (64)–2
				(75)–1
Washer (80)–6

1” Tek Screw (39)–4		3/4” Screw (2)–12			3” Bolt (37)–6
				4” Bolt (5)–2

1.Make sure that the power cord is unplugged.

With the help of a second person, carefully tip the tread- mill onto its left side as shown. Partially fold the Frame

(86)so that the treadmill is more stable. IMPORTANT:

Do not fully fold the treadmill until it is completely assembled.

Attach four Base Pads (57) (only three shown) to the bottom of the Base (69) with four 1” Tek Screws (39).

Attach a Wheel (66) to the Base (69) with a 2” Bolt (64) and a Wheel Nut (32) as shown. Do not overtighten the Wheel Nut; the Wheel should turn freely.

1
	86
		57
39	57	64
	57

	69	66
	69
	39	32
57
39