Step 1
Untie and uncoil the WIRE HARNESS attached to the front, right side of the treadmill. Pull gently on the HARNESS to remove any slack.
Step 2
Place the RIGHT HANDRAIL next to the treadmill and feed the WIRE HARNESS CONNECTOR into the slot located at the bottom of the RIGHT HANDRAIL (#10) until it exits through the top opening.
Step 3
Position the RIGHT HANDRAIL (#10) in place on the treadmill FRAME and align the mounting holes in the HANDRAIL with those in the FRAME. Insert the two HANDRAIL BOLTS (#11) and WASHERS (#12) through the HANDRAIL and into the FRAME to secure it. Tighten these BOLTS until snug, then loosen both BOLTS two complete revolutions
NOTE: The HANDRAIL BOLTS (#11) must be loose at this time to facilitate the assembly of the HANDLEBAR ASSEMBLY (#5) and the CENTER SUPPORT (#2).
CAUTION! BE CAREFUL NOT TO PINCH WIRES BETWEEN THE RIGHT HANDRAIL AND THE UNIT FRAME. REMARQUE! FAIRE ATTENTION DE NE PAS PINCER LES FILS LORSQU’ON ABAISSE LA MAIN COURANTE