Place | Life Fitness tr 8500 instruction

1 3 X 4 2

Step 4

Snap together the male and female 10-PIN CONNECTORS protruding from the top of the RIGHT HANDRAIL (#10) and the underside of the HANDLEBAR ASSEMBLY (#5). Once connected, feed the excess cable carefully back into the top of the HANDRAIL. Rest the HANDLEBAR in position on the VERTICAL HANDRAILS and install the six SCREWS (#6) and WASHERS (#7) to secure the HANDLEBAR ASSEMBLY to the two VERTICAL HANDRAILS.

Step 5

Snap the 10-PIN CONNECTOR protruding from the top of the HANDLEBAR ASSEMBLY (#5) into the

corresponding CONNECTOR in the back of the DISPLAY CONSOLE (#1). Snap the 6-PIN CONNECTOR of the extended memory board wire harness (located in the display console bracket)

into the corresponding CONNECTOR in the back of the DISPLAY CONSOLE. Install the four SCREWS (#3) in a criss- cross pattern to secure the DISPLAY CONSOLE to the

HANDLEBAR ASSEMBLY.

Step 6 Place the

HANDRAIL CENTER SUPPORT into position between the two HANDRAILS and secure it with the four CENTER SUPPORT SCREWS (#4).

Step 7

Secure the bottom sides of the HANDRAILS to the angled FRAME

BRACKETS using two SCREWS (#13) for each HANDRAIL.

THE SCREWS (#13) MUST BE FIRMLY TIGHTENED BEFORE TIGHTENING THE HANDRAIL BOLTS (#11) TO

INSURE PROPER STABILITY OF THE UPPER TREADMILL.

Step 8

Tighten the HANDRAIL BOLTS (#11) securing the base of each of the VERTICAL HANDRAILS to the FRAME of the treadmill.

Position the right (#15) and left (#16) HANDRAIL SIDE CAPS into place on the corresponding HANDRAILS and secure each with two REMOVEABLE RIVETS (#14).

Step 9

Insert the two TINNERMAN CLIPS (#19) into the slots as shown below. Check that the holes in the extrusion align with the holes in the TINNERMAN CLIPS. Set the ENDCAP (#17) into position and secure in place with the six ENDCAP SCREWS (#18).