•Do not allow other people to interfere in any way with the user or equipment during a workout.
•Allow LCD consoles to “normalize” with respect to temperature for one hour before plugging the unit in and using.
•Use these products for their intended use as described in this manual. Do not use attachments that have not been recommended by the manufacturer.
TReADmILLS
•WARNING: Keep the area 6.5 ft. (2 m) by 3 ft. (0.9 m) behind the Life Fitness treadmill clear of any obstructions, including walls, furniture, and other equipment.
•WARNING: Be sure the emergency stop lanyard is clipped to the user and in proper position on the treadmill before beginning any workout.
•WARNING: The belt centering adjustment must be performed if the belt is not between the marks indicating the maximum allowed lateral positions. Refer to Section 2 in the Activate Series Operation Manual.
•CAUTION: Risk of injury to persons – to avoid injury, use extreme caution when stepping onto or off of a moving belt. Read instruction manual before using.
•Keep the power cord away from heated surfaces. Do not pull the equipment by the power cord or use the cord as a handle. Do not run the power cord on the floor under or along the side of the treadmill. Refer to Power Cord Routing in Section 2 of this document.
•Handrails may be held to enhance stability as needed, but are not for continuous use.
•Never mount or dismount the treadmill while the running belt is moving. Use the handrails whenever additional stability is required. In case of an emergency, such as tripping, grasp the handrails, and place the feet on the side platforms.
•Never walk or jog backwards on the treadmill.
•Do not use this product in areas where aerosol spray products are being used or where oxygen is being adminis- tered. Such substances create the danger of combustion and explosion.
•When it is necessary to immobilize the treadmill, set the display to read SELECT WORKOUT. (Press the CLEAR key twice if not already there.) Then hold down the SPEED DOWN key and press the PAUSE key. The treadmill now displays “IMMOBILIZED”. In this state, the treadmill cannot be operated. The belt and incline motors are disabled. The treadmill will remain in this state across resets, power cycles, etc. To restore normal operation, repeat the same key sequence; hold down the SPEED DOWN key, and press the PAUSE key. The treadmill will display “SELECT WORKOUT” again.
SAVe THeSe INSTRUCTIONS FOR FUTURe ReFeReNCe.
4