2.With the help of a second person, carefully tip the Frame (55) and the Upright Base (85) down to the position shown. Make sure that the Base Extension (90) remains in the Upright Base.
Carefully slide the Base Cover (92) onto the bottom of the Upright Base (85). Attach the Base Cover with four 3/4” Tek Screws (44); start all four Screws before tighten- ing them. Be careful not to overtighten the Screws.
3.Attach the Base Extension (90) with four Extension Screws (87); start all four Extension Screws before tightening them.
Attach the two Thin Base Pads (83) to the Upright Base (85) in the locations shown with two 1” Tek Screws (82).
Note: One replacement Base Pad may be included. Use the Base Pad to replace any Base Pad that becomes worn.
With the help of a second person, carefully tip the Upright Base (85) back to the vertical position.
4.With the help of a second person, raise the Frame (55) to the vertical position.
While the other person holds the Frame (55), press the smaller end of the Shock (86) onto the bracket in the cen- ter of the Upright Base (85). Make sure to orient the Shock as shown. Press the other end of the Shock onto the bracket in the center of the Frame. It may be neces- sary to tip the Frame forward or back to attach the Shock.
Do not tip the Frame forward past the vertical position. Carefully lower the Frame (55) to the floor.
2 | 55 |
| |
| 44 |
| 92 |
| 90 |
| 85 |
3 |
|
| 83 |
| 82 |
| 87 |
| 85 |
| 87 |
83 | 90 |
82 | |
4 |
|
| 55 |
| 86 |
| 85 |
7