HOW to USE a Preset Program

1 Insert the key into the console.

See HOW TO TURN ON THE POWER on page 12.

2 Select one of the preset programs.

To select

one of the eight preset programs,

press the Programs button re- peatedly

until the

words “Weight Loss,” “Aerobic,” or “Performance” and the number 1, 2, or 3 appear in the lower cen- ter of the display.

As each preset program is selected, the maximum speed setting of the program and the maximum incline setting of the program will flash in the dis- play for a few seconds. The display will then show how long the program will last. A profile of the speed settings of the program will scroll across the matrix in the center of the display.

Press the Start button or the Speed increase

3 button to start the program.

A moment after the button is pressed, the tread- mill will automatically adjust to the first speed and incline settings for the program. Hold the handrails and begin walking.

Each program is divided into 20, 30, or 40 one- minute segments. One speed setting and one in- cline setting are programmed for each segment. Note: The same speed setting and/or incline setting may be programmed for two or more consecutive segments.

The speed
setting for
the first seg-
ment will be
shown in the	Current Segment
flashing

Current

Segment column of the matrix in the center of the display. (The incline settings are not shown in the

matrix.) The speed settings for the next seven segments will be shown in the seven columns to the right.

When only three seconds remain in the first seg- ment of the program, both the Current Segment column and the column to the right will flash and a series of tones will sound. If the speed and/or in- cline of the treadmill is about to change, the speed setting and/or the incline setting will flash in the display to alert you.

When the first segment is completed, all speed settings will move one column to the left. The speed setting for the second segment will then be shown in the flashing Current Segment column and the treadmill will automatically adjust to the speed and incline settings for the second seg- ment. Note: If all seven of the indicators in the Current Segment column are lit, the speed settings may move downward so that only the highest indi- cators appear in the matrix.

The program will continue in this way until the speed setting for the last segment is shown in the Current Segment column and the last segment ends. The walking belt will then slow to a stop.

If the speed or incline setting for the current segment is too high or too low, you can manually override the setting by pressing the Speed or Incline buttons. Every few times a Speed button is pressed, an additional indicator will light or darken in the Current Segment column; If any of the columns to the right of the Current Segment col- umn have the same number of lit indicators as the Current Segment column, an additional indicator may light or darken in those columns as well.

Important: When the current segment of the program ends, the treadmill will automatically adjust to the speed and incline settings for the next segment.

To stop the program at any time, press the Stop button. The time will begin to flash in the display. To restart the program, press the Start button or the Speed increase button. The walking belt will begin to move at 1 mph. When the next segment of the program begins, the treadmill will automati- cally adjust to the speed and incline settings for the next segment.

4 Follow your progress with the display.

See step 5 on page 12.