ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver 
, wire cutters 
, and rubber mallet 
.
Note: The underside of the treadmill walking belt is coated with
1.With the help of a second person, carefully raise the Uprights (69) until the treadmill is in the position shown.
Refer to the inset drawing. Insert one of the Extension Legs (102) into the treadmill as shown. Make sure that the Extension Leg is turned so the Base Pad (99) is on the bottom. Note: It may be helpful to tip the Uprights (69) forward and tap on the Extension Leg with a rubber mal- let as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same way.
2.Press the Lock Knob Sleeve (70) into the left Upright (69).
Remove the Lock Knob (68) from the Lock Pin (74). Make sure that the Lock Pin Collar (72) and the Spring (71) are on the Lock Pin.
Insert the Lock Pin (74) into the Lock Knob Sleeve (70) and the left Upright (69).
Tighten the Lock Knob (68) back onto the Lock Pin (74).
3.With the help of a second person, carefully tip the Uprights (69) down as shown. Make sure that the
Extension Legs (102) remain in the Uprights.
Attach each Extension Leg (102) with two 1” Screws
(147)and a Base Pad (99) as shown. Note: Attach the lower Screw (without the Base Pad) first.
With the help of a second person, carefully tip the Uprights (69) back to the vertical position.
Note: One replacement Base Pad (99) may be included. Use the Base Pad to replace any Base Pad that becomes worn.
1 |
|
|
| 69 |
|
|
| 69 |
|
| 102 |
|
| 99 |
2 |
|
|
| 68 |
|
|
| 71 |
|
| 72 |
| 70 | 74 |
|
| |
| 69 |
|
3 |
|
|
69 |
|
|
|
| 99 |
102 | 99 | 102 |
147 |
| |
| 147 | |
|
|
6