3. | Identify the Right Upright (85) and the Right | 3 |
|
|
|
|
| Upright Spacer (91), which are marked with |
|
|
|
| |
| “Right” stickers. Align the oval hole in the Right |
|
|
| 85 |
|
| Upright Spacer with the oval hole in the Base |
|
|
|
| |
| (95). If the holes do not line up, turn the Right | 87 |
|
|
|
|
| Upright Spacer and try again. | Wire Tie | Oval | 87 |
| |
| Insert the Upright Wire (87) through the Right |
| 91 | |||
| Upright Spacer (91) as shown. Set the Right |
|
| Hole |
| |
| Upright Spacer on the Base (95). |
|
|
| 95 | |
| Have a second person hold the Right Upright |
|
|
| Oval | |
| (85) near the Base (95). See the inset drawing. |
|
|
| ||
| Tie the wire tie in the Right Upright securely |
|
|
| Hole | |
| around the end of the Upright Wire (87). Then, |
|
|
|
|
|
| pull the other end of the wire tie until the Upright |
|
|
|
|
|
| Wire is routed completely through the Right |
|
|
|
|
|
| Upright. |
|
|
|
|
|
|
| 85 |
| 87 | Wire |
| Tie | |
4. Hold a Bolt Spacer (14) inside the lower end of | 4 |
|
the Right Upright (85). Insert a 3/8" x 4 1/4" | 7 | |
Patch Bolt (7) with a 3/8" Star Washer (11) into |
| |
the Right Upright and the Bolt Spacer. Repeat |
| 85 |
this step with a second Bolt Spacer (14), 3/8" |
| |
x 4 1/4" Patch Bolt (7), and 3/8" Star Washer |
| 11 |
(11). |
| |
Hold the Right Upright (85) against the Right |
| 87 |
| 14 | |
Upright Spacer (91). Be careful not to pinch |
| |
the Upright Wire (87). Tighten the 3/8" x 4 1/4" |
|
|
Patch Bolts (7) until the heads of the Patch Bolts |
| 91 |
touch the Right Upright; do not fully tighten |
| |
the Patch Bolts yet. |
|
|
| 8 |
|