Reebok Fitness RBTL12912 manual Walking belt is off-center or slips when walked on, Displays, Top

PROBLEMSOLUTION

4.The walking belt is off-center or slips when walked on

a.If the walking belt is off-center, first re- move the key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the allen wrench to turn the left rear roller bolt clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the bolt counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is centered.

a

	b. If the walking belt slips when walked on,	b
	first remove the key and UNPLUG THE
	POWER CORD. Using the allen wrench,
	turn both rear roller bolts clockwise 1/4 of a
	turn. When the walking belt is correctly
	tightened, you should be able to lift each
	side of the walking belt 3 to 4 inches off the
	walking platform. Be careful to keep the
	walking belt centered. Plug in the power
	cord, insert the key and carefully walk on
	the treadmill for a few minutes. Repeat until the walking belt is properly tightened.
5. The displays of the	a. Remove the key from the console and UN-	a
console do not func-	PLUG THE POWER CORD. Next, remove
		1/8”
tion properly	the screws from the hood and carefully re-
		99	11
	move the hood. Locate the Reed Switch
			12
	(17) and the Magnet (12) on the left side of	17
	the Pulley (11). Turn the Pulley until the	Top
	Magnet is aligned with the Reed Switch.
	Make sure that the gap between the	View
	Magnet and the Reed Switch is about
	1/8”. If necessary, loosen the Reed Switch
	Screw (99) and move the Reed Switch slightly. Retighten the Screw. Re-attach the
	hood and run the treadmill for a few minutes to check for a correct speed reading.

24